EVGA nForce 750i SLI Guide de l'utilisateur télécharger pdf (Page 24)

EVGA 16

Connecting Internal Headers

Front Panel Header

The front panel header on this motherboard is one connector used to connect the following

four cables:

(see Table 2 for pin definitions)

 PWRLED

Attach the front panel power LED

cable to these two pins of the connector.

The Power LED indicates the system’s status. When the system is in S0 status, the LED is

on. When the system is in S1, S3, S4, S5 status, the LED is off.

Some chassis do not have all four cables. Be sure to match the name on the

connectors to the corresponding pins.

 PWRSW

Attach the power button cable from the case to these two pins. Pressing the power button

on the front panel turns the system on and off rather than using the power supply button.

 HD_LED

Attach the hard disk drive indicator LED cable to these two pins. The HDD indicator

LED indicates the activity status of the hard disk drives.

 RESET

Attach the Reset switch cable from the front panel of the case to these two pins. The

system restarts when the

RESET switch is pressed.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 76 77

Pas de commentaire

EVGA nForce 750i SLI Guide de l'utilisateur Page 24