EVGA Z77 FTW Guide de l'utilisateur télécharger pdf (Page 13)

EVGA Z77 FTW Motherboard

Installing System Memory (DIMMs)

Your new motherboard has four 240-pin slots for DDR3 memory. These slots

support 1GB, 2GB and 4GB DDR3 DIMMs. There must be at least one

memory slot populated to ensure normal operation. Use the following the

recommendations for installing memory.

 One DIMM: If using 1 DIMM (Single Channel), install into: DIMM slot 2.

Two or Four DIMMs: If using 2 DIMMs (Dual Channel), install into:

DIMM slots 2 and 4. If using 4 DIMMs (Dual Channel), install into:

DIMM slots 1, 2, 3, and 4.

 Use the following procedure to install DIMMs. Note that there is only one

gap near the center of the DIMM slot. This slot matches the slot on the

DIMM to ensure the component is installed properly.

1. Unlock a DIMM slot by pressing the module clips outward.

Align the memory module to the DIMM slot, and insert the module vertically

into the DIMM slot. The plastic clips at both sides of the DIMM slot

automatically lock the DIMM into the connector.

DIMM Slot 1

DIMM Slot 2

DIMM Slot 3

DIMM Slot 4

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 33 34

Pas de commentaire

EVGA Z77 FTW Guide de l'utilisateur Page 13